WXStar DIY Kit Assembly

The WXStar is provided as a DIY kit. If you can fly a plane, you can assemble this!

What's in the Kit & Assembly


  • WXStar mainboard - fully assembled and tested
  • 3D printed enclosure - top and bottom parts
  • Screws & screwdriver

  • Fit the mainboard into the enclosure, secure with the provided screws. Detailed instructions are included with every kit.

    Mounting Holes

    The enclosure offers two mounting patterns:

    Pattern Screws
    75 × 35 mm (VESA) M4
    75 × 75 mm M4, typically 25 mm long

    The holes stop slightly below the top surface to keep the enclosure looking clean. To use them: drill through from the back side using the existing holes as a guide, insert nuts in the slots, and attach with bolts of the appropriate size.

    Why a DIY Kit?

    • Maker-friendly: many pilots enjoy 3D printing their own enclosures or modifying them.
    • Faster & cheaper to market: lower certification requirements allow us to deliver this at a much lower price than a fully certified consumer device.

    Certification Notice

    WXStar is a DIY kit for pilots. It is not certified as consumer electronics or as an EASA/FAA aviation device. Check which requirements apply to your installation and use.

    The producer of the WXStar DIY Kit is WXStar UG (haftungsbeschränkt), Berlin, Germany. Golze Engineering is a dealer for this product.





    Login
    (c) 2026   Imprint   Privacy Policy   Contact